How To Install Double Dog Run - Two Dog Tie Out Stake

How to install the Double Dog Run

Step-by-step written instructions on how to install the Double Dog Run System:

1. Place the black square ABS base plate on the ground where you want to install your dog tie out stake.
2. Place the orange dog tie out stake through the center hole of base plate and turn counter clockwise.
3. Use the screwdriver you will need as leverage to turn the dog tie out stake further into the ground. if that gets difficult use a hammer as leverage by hooking it through the D-ring on the top of the dog tie out stake. (see video)
4. Attach the hardware: jaw and eye swivel attaches to the orange D-ring, the Quick link is used to connect the two swivels together. The order should be the jaw and eye, quick link then the eye and eye swivel.
5. Slide the topper into place and be sure to fish the hardware through the hole in the topper before attaching the topper.
6. Attach topper by screwing it into the base plate using the pre-drilled holes as a guide.
7. Attach both dog tie out cables to the upper most link on the eye and eye swivel side-by-side.
8. Attach dogs to other ends of the dog tie out cables.
9. DONE!